1975-1986 C10 LS Swap Kit Level 1, T56 Manual (SE1-C107586-LSX-M)

Description

This Holley Swap Essentials Level 1 kit is the mounting package for putting a GM Gen III/IV LS engine in 1975-1986 GM C10 two-wheel-drive trucks. It bundles the engine brackets, clamshell engine mounts with polyurethane inserts, through-bolt hardware, transmission crossmember and polyurethane transmission mount, matched for a T56 or T56 Magnum manual transmission.

Holley designed the mounts in CAD to set the driveline angles, which cuts vibration and helps put the power to the ground. The engine position leaves room to route a dual exhaust up to 3 inches, and the black polyurethane inserts twist less than factory rubber mounts.

Features

• Engine and transmission mounting package for LS swaps
• Matched to a T56 or T56 Magnum manual transmission
• Hooker BlackHeart engine brackets and clamshell engine mounts
• Hooker BlackHeart transmission crossmember and polyurethane transmission mount
• CAD-designed to set driveline angles and cut vibration
• Room for a dual exhaust up to 3 inches
• Black polyurethane mount inserts twist less than factory rubber
• Engine mount through-bolt hardware included

Notes

• For two-wheel-drive trucks only.
• For GM Gen III/IV LS engines with a T56 or T56 Magnum manual transmission.
• Holley classes this kit as an engine swap part for fitting a later-model engine in a classic vehicle. Check the rules for engine swaps where you live before you start.