2024-2026 Tacoma 3" SST3.3 Lift Kit w/ Falcon 3.3 Fast Adjust Shocks & Forged Upper Control Arms (62-54361)

Description

ReadyLIFT's 3" SST3.3 Suspension System for the 2024-2026 Toyota Tacoma combines Falcon 3.3 Fast Adjust struts and shocks with ReadyLIFT's new forged aluminum upper control arms. Built for Tacomas with factory rear coil springs, it adds 3" up front and 2" in the rear for larger tires, and the Fast Adjust dampers let you tune the ride from daily comfort to firm off-road control.

Part Number: 62-54361

Features

• 3" front and 2" rear lift for larger tires and a more aggressive stance
• Falcon 3.3 Fast Adjust reservoir struts and shocks: a 3-position main compression knob (Soft, Custom, Firm) plus an 8-position Micro Adjust dial to fine-tune the Custom setting
• Monotube reservoir dampers with Volume Optimized Damping (VOD), high-temperature oil and hard-anodized 6061-T6 aluminum bodies
• Forged aluminum upper control arms, stronger and more rigid than ReadyLIFT's previous tubular steel arms
• Corrected arm geometry and optimized component clearance support proper alignment and suspension travel at lifted ride height
• Pro Series heavy-duty high-angle ball joints allow more articulation while keeping a factory-like ride
• Maintenance-free Terrain Control Technology (TCT) pivot bushings stay quiet without routine lubrication
• Type III hard-anodized finish, billet aluminum O-ring dust caps and sealed ball joint assemblies keep out corrosion, dirt and debris
• Full-use front skid plate integrates with factory components

Tire Fitment:

• Up to 285/75R17 on an 8" wide, +35 offset wheel with no trimming
• Up to 295/55R20 on an 8.5" wide, +35 offset wheel
• 315/70R17 or 35x12.50R17 with minor trimming
• Fitment is based on Wheel Pros wheels and Nitto tires. Test fit every wheel and tire combination before installing.

Includes

• Forged aluminum upper control arms, left and right
• Falcon 3.3 Fast Adjust front struts, left and right
• Falcon 3.3 Fast Adjust rear shocks, left and right
• Rear coil springs
• Front sway bar extensions
• Front skid plate
• Front differential drop brackets, spacers and bushings
• Falcon bump stops, rear bump stop cups and pads
• Rear sway bar bracket and rear brake line bracket
• Crush sleeves, washers and hardware pack

Notes

• Not compatible with 2024 Tacoma models equipped with rear leaf springs.
• Not compatible with Adaptive Variable Suspension (AVS) models. Installing it on an AVS vehicle will illuminate a dash light.
• ReadyLIFT has not confirmed fitment with the optional sway bar disconnect.
• Estimated installation time is about 7 hours, excluding alignment and wheel and tire assembly. Installation by a certified mechanic is recommended.
• An alignment is required after installation. Headlamp aim and any ADAS cameras or sensors should also be checked and adjusted.