Rope Retention Pulley and 7/16 in x 10 in Soft Shackle Combo (00264)

This combo pairs the full size Rope Retention Pulley for 5/16 to 1/2 in synthetic rope with the 7/16 in x 10 in Standard Duty soft shackle it is meant to run with, so you have a complete 22,000 lb WLL redirect or double line setup in one box. The patented rubber retention fingers keep the rope in the groove during slack, and the whole kit weighs less than a single steel snatch block.

Features

• Bundles the full size Rope Retention Pulley with a 7/16 in x 10 in Standard Duty soft shackle
• Patented rubber retention fingers keep synthetic rope in the groove when the line goes slack
• Doubles pulling power or redirects the winch line without a heavy snatch block
• Oversized hole radius gives the soft shackle a smooth bearing surface and keeps its legs off the edges
• Critical friction surface is PTFE treated for slickness and heat dissipation
• Pulley is billet machined 6000 series aluminum with a Mil-A-8625 F hard anodized surface
• No pinch points, so fewer crushed fingers during rigging
• For synthetic rope only
• Made in the USA

Specifications

• Pulley rope compatibility: synthetic rope 5/16 to 1/2 in (8 to 12 mm)
• Pulley working load limit: 22,000 lb (97.9 kN)
• Pulley weight: 21 oz (595 g)
• Pulley material and finish: billet 6000 series aluminum, hard anodized
• Soft shackle: Standard Duty, 7/16 in x 10 in

A friction pulley does lose some efficiency, roughly 10 to 20 percent depending on load, so it will not match a bearing snatch block for pure mechanical advantage. What you get instead is a pulley you can rig in seconds, with no pinch points for fingers, that keeps the rope captured in the groove when the line goes slack, and weighs a fraction of a steel block.