2022-2026 Tundra Soft Tri-Fold Tonneau Cover w/ Utility Tracks 78.7in Bed (19-24095)

This is the quick, no fuss way to cover the long bed of your Tundra. Three sections fold forward against the cab in seconds and drop back down just as fast, so you can go from fully covered to wide open bed without tools and without pulling the cover off the truck. The skin is tear resistant 24 oz marine grade vinyl stretched over aircraft aluminum hinged cross bars, and adjustable tension controls let you dial the vinyl drum tight so it stays quiet instead of flapping at highway speed.

Weathertight hook and loop seals run the length of the rails, an EPDM rubber seal closes out the perimeter, and an internal drainage system routes water away from whatever you are hauling. Pull and twist latches hold the rear section closed and the cover sits above the bed rail with a molded black finish that looks right on any trim level. Installation is custom fit and requires no drilling, because the cover mounts to the factory utility track system already in your bed. Slide the brackets in, snug them down and you are done.

Features

• Custom-fit design with no-drill installation
• Three-section fold design
• Tear-resistant 24 oz marine-grade vinyl
• Aircraft aluminum cross bars with adjustable tension controls
• Internal drainage system
• Weathertight hook and loop seals
• EPDM rubber seal
• Pull and twist latches
• Mounts above the bed rail
• Molded black finish

Notes

• Requires the factory utility track / deck rail system, the cover mounts entirely through utility track brackets
• Fits the 78.7in bed only
• The latch is not accessible when the tailgate is closed and locked